Snowflake Ornament by Maryanne Walczak
Supply List for Snowflake Ornament:
- 30mm 6704 Snowflake Pendant – Crystal AB – Quantity = 1
- 10mm 5810 Pearl – White – Quantity = 1
- 12mm 5810 Pearl – White – Quantity = 1
- 5mm Jump Rings – Silver – Quantity = 2
- 20 Gauge Artistic Wire – Brass Color – Quantity = 3 pieces of 4 inches each, 1 piece that is 5 Inches
Step 1:
Place the long 5 inch wire through the hole of the snowflake pendant, leaving 1 inch of wire on one side
Step 2:
Crisscross the wires. Be sure to leave enough room so that pendant can still move freely.
Step 3:
Using the short wire, wrap up the long wire (at least twice)
Step 4:
Trim the short wire close to the long wire.
Step 5:
Using the long piece of wire, make a wire wrapped loop
Step 6:
Using 2 of the 4 inch pieces of wire, make a wire wrapped loop (one wire wrapped loop on each as shown)
Step 7:
Place the 10mm Pearl on one wire wrapped piece and the 12 mm Pearl on the other wire wrapped piece
Step 8:
Finish each piece of wire by making another wrapped wire loop on the other side of each pearl.
Step 9:
Using the jump rings, connect all components (10mm wire wrapped pearl connected to the 12mm wire wrapped pearl which is then connected to the Snowflake pendant
Step 10:
Make a simple loop on the last piece of 4 inch wire
Step 11:
Using something round, form a circle with your wire. I used a small 1 inch plastic container but you can also use a peg from the WigJig.
Step 12:
Using flat nose pliers, bend the wire 90 degrees leaving an opening of approximately 1 inch
Step 13:
There should be approximately 0.4 inches (or 1 centimetre) of wire left at the bottom. If not, cut any excess wire. Now form a simple loop.
Step 14:
Before closing the simple loop, attach to the rest of the ornament.