Lifesavers Necklace

1. String one end of wire through a crimp bead, then through a jump ring and back through the crimp bead. Crimp the bead to secure.
2. String on eight 5000 4mm White Alabaster Round Beads, one 5139 12.5mm Amethyst Ring Bead with one 5000 4mm White Alabaster Round Bead in the middle of the Ring Bead, then two 5000 4mm White Alabaster Round Beads.
3. String on one 5139 12.5mm Olivine Ring Bead with one 5000 4mm White Alabaster Round Bead in the middle, then add two 5000 4mm White Alabaster Round Beads.
4. Continue this pattern using the Crystal Red Magma Ring Bead, the Violet Ring Bead, and finally the Light Topaz Ring Bead. Continue until you have used all the Ring Beads and then add eight more 5000 4mm White Alabaster Round Beads.
5. String on a crimp bead, string the wire through the loop at the bottom of the lobster clasp and then back through the crimp bead. Pull the wire to take up any remaining slack in the wire (do not pull too tightly; beads should drape easily). Crimp the crimp bead to secure. String remaining wire back through a few beads on both sides and cut off remaing wire.

Download the full PDF below!