Fancy Ornament Holder
Fancy Ornament Holder
Supplies:
?
Step 1:
Make a simple loop at the end of the 6 inch wire
Step 2:
Using something round, form a circle with your wire. I used a small 1 inch plastic container but you can also use a peg from the WigJig.
Step 3:
Using flat nose pliers, bend the wire 90 degrees leaving an opening of approximately 1 inch
Step 4:
Place the 8mm crystal, the rondelle, and the other 8mm crystal on to the wire (in this order).
Step 5:
Cut the excess wire at the bottom, leaving approximately 0.4 inches (or 1 centimeter)
Step 6:
Form a simple loop at the bottom