Frozen Inspired Earrings by Maryanne Walczak
Created By Maryanne Walczak for Dreamtime Creations
Show off your inner princess with these SWAROVSKI Frozen inspired earrings - Make your own in less than 15 minutes!
Supply List (as shown in the picture above, from left to right):
- 6mm 5301 Bicone Beads – Aquamarine - Quantity = 8
- 6mm 5810 Pearls – White – Quantity = 4
- 8mm 5000 Round Beads – Aquamarine - Quantity = 4
- 6mm 5000 Round Beads – Crystal AB - Quantity = 4
- 10mm 5810 Pearls – White – Quantity = 2
- 1.5 inch Head Pins – 20 Gauge - Silver Plated – Quantity = 22
- Earring Fish Hooks – Silver Plated – Quantity = 2
- 6mm Jump Rings - 19 Gauge – Silver Plated – Quantity = 10
Step 1:
Using the following beads and head pins, make simple loops as shown below:
6mm 5301 Bicone Beads – Aquamarine - Quantity = 4
6mm 5810 Pearls – White – Quantity = 2
8mm 5000 Round Beads – Aquamarine - Quantity = 2
6mm 5000 Round Beads – Crystal AB - Quantity = 2
10mm 5810 Pearls – White – Quantity = 1
Step 2:
Open 4 of the Jump Rings.
Step 3:
Attach one of the Jump Rings to the 10mm 5810 White Pearl.
Step 4:
Attach one of the Jump Rings to the Jump Ring in Step 3 and also attach the two 6mm 5000 Round Beads in the Crystal AB. Then place each of the crystals on either side of the Jump Rings as shown.
Step 5:
Attach another Jump Ring to the last Jump Ring from Step 4 but make sure the position is between the 2 Crystal AB Beads as shown below. Before closing the Jump Ring, slip on 2 of the Aquamarine 8mm Round Crystal Beads. Close the Jump Ring and position each of the Aquamarine Crystals on either side of the Jump Ring.
Step 6:
Attach another Jump Ring to the last Jump Ring from Step 5 but make sure the position is between the 2 Aquamarine Crystals. Before closing the Jump Ring, slip on 2 of the 6mm White Pearls. Close the Jump Ring and position each of the Pearls on either side of the Jump Ring as shown below.
Step 7:
Attach another Jump Ring to the last Jump Ring from Step 6 but make sure the position is between the 2 White Pearls. Before closing the Jump Ring, slip on 4 of the 6mm Aquamarine Bicone Beads. Close the Jump Ring and position 2 of the Aquamarine Bicone Beads on either side of the Jump Ring as shown below.
Step 8:
Attach the Jump Ring to the Earring Fish Hook by slightly opening up the last Jump Ring from Step 7 and slipping the Fish Hook through the Jump Ring. Just be sure to have 2 of the Aquamarine Bicone Beads on each side of the Fish Hook. One earring is now complete.
Step 9:
Repeat Steps 1 through 8 to create the second earring.
Now that both earrings are complete, slip them on and be that Princess!